The proper functioning of SENSO Motor depends on manufacturing the roller and its correct installation. The shutter should move smoothly, without any obstacles along the slides. Pay careful attention to:

• The vertical fitting of the slides,

• Smooth work of the shaft bearing,

• Deflection of the shaft (of the roll tube) caused by exceeding the width or weight of the shutter,

• The high quality of shutter, especially of profile’s work in locks – shutter’s beam cannot rub against the box or its elements, e.x. thermal insulation (polystyrene) in the top-mounted roller shutters,

• Using of high quality coat hangers which do not become deformed while using the roller.

Using of the mob.iq [ M35 EZRS ] motors requires fulfilling the additional conditions. This is a consequence of using the 40 mm octagonal roll tubes in which between roller-tube and the motor’s housing there is a small space. There are some instructions that should be followed:

• Pipe’s seam cannot rub against motor’s housing,

• We recommend using pipes with the outer seam,

• Motor’s position in the octagonal roll tube should enable the hanger’s installation in the largest space between pipe and motor’s housing,

• The most safest is the hanger with the low catch.

 

Shutter assembled not according to the good roller’s installation practice that doesn’t show any tendency to going down /rolling can be the cause of disturbance of the obstacle detection system in the mob.iq [ M35 EZRS ] tubular motor.

Pay careful attention to: Ovalization of the shutter’s beam. Situation when the shutter’s oval is located directly over the slide’s intakes is the most optimal option for correct work of the tubular motor. The negative factor can be eliminated by using proper rings making the diameter bigger or by ballasting the endslat.

The mob.iq [ M35 EZRS ] tubular motor enables setting the end limit switches in the automatic mode – using the buffers is required. In this case, following issues have to be taken into consideration:

• The most profitable is using of the inside buffers installed in the down endslat,

• In case of using the outer buffers that are installed in the down endslat, they should be located on the right side of shutter. The point-intake designed for screwing should be located in the distance not larger than 100 mm from the shutter’s edge.

1. Plug mob.iq [ M35 EZRS ] motor to the power supply according to schema at the end of instruction. Green diode in PROGRAMMING BUTTON is on. In the other case you need to exclude motor from Z-Wave network according to point 4 of this instruction.

2. Turn your controller into INCLUDE mode (see instruction of your controller).

3. Press the PROGRAMMING BUTTON onmob.iq [ M35 EZRS ]motor.

4. Motor is detected by controller and included into Z-Wave network – the led diode is off.

1. Turn your controller into exclude mode (see instruction of your controller).

2. Press the PROGRAMMING BUTTON onmob.iq [ M35 EZRS ]motor.

3. Motor is detected by controller and excluded from Z-Wave network – the led diode is on.

There are following association groups in mob.iq EZRS motor:

I ASSOCIATION GROUP – allows to send information about failures, errors and alarms directly to the controller (max. 5 devices).

II ASSOCIATION GROUP – allows to send direct steering commands between SLAVE devices without participation of PRIMARY controller (max. 5 devices).

III ASSOCIATION GROUP – allows to send direct steering commands (BASIC_SET with value 0xFF) to other devices if error is detected (max. 5 devices).